Skip to Content

Is an EMS worth it? How to assess value and payback from your own factory data

Count the full project cost, set a baseline first, then measure savings from real measures
November 5, 2026 by
Is an EMS worth it? How to assess value and payback from your own factory data
DIGITECHX CO.,LTD.

The question executives ask most is when an EMS pays back. A credible answer must come from the factory's own data, not an average from elsewhere. This article explains what to prepare to assess value before and after investing.

01

Count the full project cost

The software price is only one part. Value must be compared against the full project budget.

Software and services

System cost, setup, customisation and maintenance

Equipment and installation

Additional meters, gateways, server, wiring and on-site work, which depend on the number of measurement points

02

Savings come from measures, not from the system

Set a baseline before measures start, then compare afterwards with the same boundary and comparable output. That difference can be used to calculate value.

Set a baseline

Record data from before improvements, with production volume and operating hours

Calculate payback

Payback period = total investment ÷ measured annual savings

Total investmentSoftware + equipment + installationAnnual savingsMeasured against the baselinePaybackyears÷=
Payback formula, using the factory's own figures

“A credible payback figure must come from the factory's own data”

03

Data for assessing before you buy

Before installing a system, a factory can make a first estimate from data it already has, as long as the assumptions are clearly stated.

Electricity data

At least 12 months of bills by electricity account, and demand data if available

Production data

Equipment schedules, production shifts and a list of high-consumption equipment

Frequently asked questions

What percentage does an EMS save?

No single figure fits every factory. Results depend on existing usage and the measures taken, so assess them from the factory's own data.

Can value be assessed without area-level data?

A first estimate can use bills and production schedules, and it becomes more precise once measurement-point data is available.

Try the system

See targets and post-improvement results in the demo

The demo shows progress against targets and electricity use before and after measures

The demo uses simulated data

EMS demo screenClick to open the demo

Next · Part 5 of 5

How to start an EMS: five steps from surveying measurement points to daily use and expansion

Start from the questions executives need answered, then define meters, systems and phases

Read the next part →

Further reading: Energy management reports: prepare factory data that can be checked

References

  1. DOE 50001 Ready: Energy Performance Indicators and Energy Baselines
  2. DOE 50001 Ready: Monitoring and Measurement of Energy Performance Improvement
  3. DOE 50001 Ready: Improvement Opportunities

Information and sources reviewed: 6 November 2026

How does an EMS help reduce electricity costs? From data to measures the factory team can take
Find unusual usage, manage peaks and rank measures before investing
Contact options Hide contact options